#26 - Drill Press ‘Tips & Techniques’

I thought that for this week, I would just go over some of the little tidbits of information that I like to call ‘Tips & Techniques’. Since we have been discussing Drill Presses the past 2 weeks, we might as well stay on topic.

One of the areas that folks need some assistance with is that of choosing the right DP speed for their particular project. The main rule of thumb is: ‘The harder the material, the slower the bit needs to turn.’ Right behind that comes this: ‘The bigger your bit, the slower it needs to turn’. How that plays out is like this. If you’re drilling the same size hole in wood and metal, the speed will need to be slowed down for drilling into metal. By the same token, if you’re drilling into pine wood and making a ¼” hole and a 2-1/4” hole, slow it down for the 2-1/4” hole. It may be that not much speed change is needed between these two, but the idea is that you don’t usually want a 2-1/4 cutter turning as fast as a small ¼ bit.

Now, let’s talk safety. First and foremost, dress appropriately when using a Drill Press. Wear your safety glasses, roll up your long sleeves and pull your hair back out of the way (IF your hair is that long). I once saw a training film that showed what happened when a lady got her long hair tangled in the Drill Press she was operating. It was not a pretty sight. She reminded me of what Custer’s men must have looked like after being scalped.

After you have all those bases covered, here’s another ‘first and foremost’- ALWAYS clamp your work. I cannot over-emphasize this. Yes, it’s a pain and not always convenient but it IS necessary. I have a nice 2” long scar on my left forearm that is a constant reminder of this. The very afternoon that I was going to drive my dirt track racecar for the first time, I was making an accelerator bracket and need to drill a hole in it. The bracket was just 8” long, ¾” flat stock, with one end bent at a 45 and that was where I needed the hole. So I go to my DP and hold the long part and place the bent area on the table under the bit. I started drilling the hole and OOPS…it grabbed and swung around 360 degrees and in the blink of an eye, it made a few revolutions before I could get it shut off. Unfortunately, on that first swing, the top end of the stock sliced my wrist open and I wear that reminder to this day. It looks like I tried to commit suicide. So, I tell everyone - clamp your stock.

Send your questions or comments to:
Toolsmartz@bellsouth.net and we’ll see what we can do to help you.
_______________________________________________________________
Any views or opinions presented in this article are solely those of the author and do not necessarily represent those of this newspaper. Neither the author, nor this newspaper, accepts any liability for the content of this article, or for the consequences of any actions taken on the basis of the information provided.